AquaPure AQUAPURE-C-COMPLETE Manuel d'instructions télécharger pdf (Page 7)

Drilling Hole through Porcelain/Enamel/Ceramic Sinks with Sheet Metal or Case Iron Base

Recommended Tools:

• VariableSpeedDrill

• PorcelainCutterToolSet(9/16”Size)

• Plumber’sPutty

Note: It is important to understand this procedure.

1. Theglassylayerofporcelain/enamel/ceramicmustbescoredthroughtothemetalbase,creatingadisk.

2. Thisdiskmustberemovedwhileprotectingthesurroundingdecorativecoatingagainstchippingorfracturing.

3. The base metal must be drilled through to complete the hole.

Procedure:

1. Markcenterfor9/16”hole.

2. Formadamofshallowputtyaroundholelocationandllwithenoughwatertolubricatecarbidedrillbit.

3. Carefully drill pilot hole through porcelain/enamel/ceramic and base metal using a carbide pilot drill. Always operate

drillwithlightpressureatslowspeed(300-400rpm).

4. Drillporcelain/enamel/ceramicusingspecial9/16”cuttingtool,makingcertainacompleteringhasbeencutthrough

tothesink’smetalbase.

5. Changetometalcuttingdrillbitanddrilloutthecenterofthering,makingsurenottocontactotherrimofdecorative

coating.Cutthroughmetalsinkbase.

DRILLING HOLE THROUGH

PORCELAIN/ENAMEL/CERAMIC SINKS

1. Graspcartridgeandturntotheleft(counterclockwise)untilcartridgecomestoacompletestop.Gentlypulldown-

wardtoremove.

2. Ensurethato-ringsarepresentonthecartridgeandareseatedintogrooves;moisteno-ringswithwater.DONOTuse

any petroleum products to lubricate the o-rings.

3. Aligntabsofnewfiltercartridgewithexistingfilterheadandinsertnewfiltercartridgeintohead.Turncar-

tridgetotheright(clockwise)untilcartridgestops.

4. Opentheinletshut-offvalveandflushnewcartridgeforfour(4)gallons(approximately5minutes).

FILTER CARTRIDGE REPLACEMENT INSTRUCTIONS

Water Leaks at Push-In Connections:

Pushtubinginasfarasitwillgo.Ifleakingcontinues,shutoffwaterattheoriginalvalveandremovewaterlinebypush-

inginontheconnectorcollarwhilepullingthetubingaway.Inspecttubingforcracksandscratches.Iftubingiscracked

orscratched,simplycutthatportionawayandreinserttubingintopush-intting.

Makesuretubingiscutstraight.Ifnot,recut.

Ifwaterleaks,pleaseverifythattheo-ringisproperlyseatedinitsgroove.

Water Does Not Flow From The Drinking Water System Faucet:

Checktoseeifthemainwaterlinevalveisopen,allowingwatertoowtothelter.

Water Appears Cloudy or Air Comes Out of the Drinking Water System Faucet:

Flushthelterforfour(4)gallons(approx.5minutes)toremoveanytrappedair.

TROUBLESHOOTING GUIDE

To reduce the risk aof eye injury while drilling counter-tops for faucet installation:

 • SafetyglassesMUSTbewornduringthesinkholddrillingoperations.

CAUTION

To reduce the risk associated with property damage due to water leakage:

 • Thedisposableltercartridgemustbereplacedeverytwelve(12)monthsoratthespeciedservicecycle.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

AquaPure AQUAPURE-C-COMPLETE Manuel d'instructions Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Articles sanitaires AquaPure AQUAPURE-C-COMPLETE